• The appliance is for indoor use only.
• This appliance is intended to be used exclusively for the storage of wine.
• This appliance is using flammability refrigerant. So never damage the cooling pipe work during the
transportation.
• Connect the appliance to a single socket, leaving a 30 mm gap of space between the back of the
wine cellar and the wall. Be careful to support it, so that your wine cooler is perfectly level (the use
of a spirit level is recommended). This will prevent any movement due to instability, generating noise
and vibration, and will ensure that the door seals perfectly.
Attention
• Store wine in sealed bottles when they are lengthened.
• Do not overload the cabinet.
• Do not open the door unless necessary.
• Do not cover shelves with aluminum foil or any other shelf material which may prevent air circulation.
• Should the wine cooler be left empty for long periods it is suggested that the appliance is unplugged,
and after careful cleaning, leave the door ajar to allow air to circulate inside the cabinet in order to
avoid possible condensation, mold or odors forming.
CAUTION: please keep the appliance away from substance, which can cause ignition.
Wall stopper installation
2 wall stoppers are included in the IM bag. Before using your wine cooler, please follow below photo to
install wall stoppers onto the back of the wine cooler, they will keep the space between wall and wine
cooler to secure enough ventilation and protect the wine cooler.
Below is photo after wall stopper being installed:
To Next Page
Loading...
Need help?
General
