16
4. INSTALLATION INSTRUCTIONS
Before using your temperature control cellar
• Remove the inner and outer packaging.
• Allow the appliance to rest for two hours before switching it on.
• Clean the inside using a soft cloth and lukewarm water.
Using your temperature control cellar:
The appliance must be positioned in a room with an ideal ambient temperature of 25°C.
If the ambient temperature is higher or lower, the appliance’s performance may be affected.
Installing your temperature control cellar:
• This appliance is designed for free-standing installation.
• Position it in a place with sufficient strength to support its weight when loaded. To ensure that it is level,
adjust the height of the feet underneath.
• To get the best from your appliance with the lowest energy consumption, do not place the appliance
close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a
room which is too cold.
• Connect the appliance to a single socket, leaving a 10 mm gap between the back of it and the wall and 2
cm on each side. Be careful to support it, so that it is perfectly level. (Use of a spirit level is
recommended). This will prevent any movement due to instability, causing noise and vibration, and will
ensure that the door seals perfectly.
Selecting the temperature
• You can choose the desired temperature in the compartment, using the / buttons. The temperature
selected increases/decreases by 1°C with each button press.
This appliance belongs to category 10 according to the european regulation N°1060/2010. The temperature
setting is from 14° to 18°C.
However the appliance’s technical performances allow to reach a wider temperature range from 12° to 18°C.
The interior light may be switched on or off using the button.
To Next Page
Loading...
Need help?
General
