Need help?Do you have a question about the Climatouch CT0-7TC-32H and is the answer not in the manual?
General| Category | Thermostat |
|---|---|
| Model | CT0-7TC-32H |
| Display | Touchscreen |
| Power Source | 24 VAC |
| Wi-Fi | Yes |
| Programmable | 7-day programmable |
| Humidity Control | Yes |
| Backlight | Yes |
| Remote Access | Yes, via app |
Configure daylight saving time settings.
Input air filter run time for filter change alerts.
Enter HVAC consumption and cost for energy tracking.
Protect thermostat access with PIN and lock modes.
Set custom messages to display at programmable intervals.
Select display units for temperature: Celsius or Fahrenheit.
Choose the type of heating and cooling equipment installed.
Set maximum compressor cycles per hour for optimal performance.
Define minimum temperature difference for Auto Mode changes.
Set temp difference before 1st stage heating/cooling initiation.
Set temp difference between 1st and 2nd stage operation.
Set temp difference between 2nd and 3rd stage operation.
Reverse Heat Pump OB Valve contact for HEAT or COOL.
Specify minutes Stage 1 runs before Stage 2 activates.
Configure Heat Pump status when furnace is active.
Control humidifier fan for steam or drum humidifiers.
Manage dehumidifier fan for separate equipment or AC use.
Configure DH relay for variable speed fan (open/closed).
Link dehumidifier setpoint to compressor and AC operation.
Adjust temperature readings based on thermometer comparison.
Adjust humidity readings based on hygrometer comparison.
Convert to non-programmable mode via reset button.
Understand simplified operation temperature and fan modes.
Troubleshoot unresponsive buttons using reset procedure.
Diagnose issues with AC, heating, or blank screen.
Resolve issues with partial or full lock modes.
Reset forgotten PIN to regain thermostat access.
Understand common wire (C) necessity for gas furnace operation.
Solutions for systems lacking a common wire.
Verify operation when Heat Pump and Furnace run concurrently.
Use two transformers and circuit board traces.
Two-year coverage for defects in materials, workmanship, and software.
Conditions like physical damage or misuse are not covered.
Steps to contact and return products for repair.
To Next Page
