To Next PageTo Next Page
Need help?Do you have a question about the CLIMAVENETA W3000 and is the answer not in the manual?
General| Brand | CLIMAVENETA |
|---|---|
| Model | W3000 |
| Category | Thermostat |
| Language | English |
Details of keys, LEDs, and their functions for different W3000 interfaces.
Visual representation of menu trees for W3000 and W3000 base interfaces.
Overview of hardware options and physical connections for W3000 units.
Details on connecting units using the base-expansion method.
Explanation of master-slave and mixed connection methods for units.
Details on configuring analogue inputs and installing clock/serial cards.
Procedures for setting keyboard and card addresses for proper operation.
Steps for configuring specific card types and the plan network.
Instructions for connecting remote keyboards using T shunts.
Procedures for turning the unit on and off using keys, parameters, or digital inputs.
Methods for controlling unit power using time schedules and supervision.
How to set the unit's operating mode (chiller, heat pump, recovery, etc.).
Methods for setting operating modes using digital signals and protocols.
Navigating the user menu and understanding adjustment methods.
Details on adjusting centrifugal compressors, including single-unit examples.
How to perform modulating adjustment for screw compressors and set recovery parameters.
How to set different operating setpoints and configure time bands.
Overview of the manufacturer menu structure and access procedures.
Explanation of the freecooling system and its valve control mechanisms.
Details on condensation adjustment types and fan control strategies.
List of alarms, their descriptions, and reset methods.
Masks for main display, unit type, compressor, pump, and global settings.
Masks for condensation, freecooling, defrost, and alarm settings.
Masks for calibration, service, digital/analogue I/O, and clock settings.
Masks detailing analogue I/O for master/slave units and setpoint menus.
Masks for display, user menu, supervisor, serial comms, and I/O status.
Masks for setpoints, unit details, compressor hours, and alarms.
Parameters for unit type, compressors, modulation, condensation, and freecooling.
Parameters for defrost, alarms, pressure controls, calibration, and adjustments.
Parameters for time bands, supervisor, communication, and system configuration.
Detailed I/O list for 'S' hardware in various unit configurations.
Detailed I/O list for 'M' hardware in various unit configurations.
I/O mapping for 'L' hardware in hermetic, centrifuge, water-water units.
Detailed I/O list for 'HL' hardware in various unit configurations.
Detailed I/O list for 'B' hardware in various unit configurations.
Details of 'E' expansion for chillers with recovery, address 1.
Details of 'M' expansion for hermetic compressors, address 2.
Details of 'E' expansion for chillers with freecooling, address 3.
Details of 'E' expansion for units with more than 4 compressors, address 4.
Details of 'E' expansions for chillers with heat pumps, address 5.
Details of 'E' expansion for chillers with setpoint variation, address 3.
Details of 'E' expansion for chillers with recovery, addresses 1 and 5.
Details of 'E' expansion for chillers with heat pumps, address 5.
Details of 'E' expansion for chillers with setpoint variation, address 3.
Explanation of symbols used in W3000 and W3000 compact interface masks.
