110
M0CZ00007-03
PARAMETERS ACCESS / VISUALIZATION
select
2
ATTENTION
The access to parameters or modifications are allowed only to the
installer who assumes all responsibility, in case of doubts please
contact Clivet S.p.A.
For any changes not permitted or not approved by Clivet S.p.A., the
same declines any responsibility for malfunctions and/or damages to
the unit/system.
The operations listed below are required only for particular calibrations
and configurations, they are therefore addressed only to qualified
authorized assistance centres.
select
3
select
4
3 - Other parameters
Parameter access (read/write Modbus commands)
2
press for 2 sec.
1
1
4
2
To Next Page
Loading...