15
M0CZ00007-03
HEAT PUMP
3 - Modify the correction
example: + 1.0°C
5 - Set the required values:
Max 30°C
Min. 15°C
select 1
select 3
3
AIR SET POINT COMPENSATION BASED ON THE OUTSIDE
TEMPERATURE
The air temperature set point correction function is enabled in
COOLING ONLY mode.
The function applies a correction to the zone set point based on the
outside temperature value.
The same outside temperature limits set for the climate curve of the
PDC are used.
1
The function is only combined with the not mixed circuit.
2 - Set on Summer
3 - Maximum correction of ambient air set point (0°C max 2°C)
4 - Enabling room air set point correction
5 - Outside temperature limits setting
2
5
4
3
select 5
To Next Page
Loading...