Need help?Do you have a question about the CLIVET WDH-iK4 and is the answer not in the manual?
General| Brand | CLIVET |
|---|---|
| Model | WDH-iK4 |
| Category | Industrial Equipment |
| Language | English |
Information on potential dangers and necessary precautions for safe operation.
Specifies the designated applications and limitations for the unit's operation.
Procedures for accepting unit delivery and verifying its condition.
Recommendations for storing the unit, including environmental conditions.
Methods and considerations for lifting the unit using balance or spacer bars.
Key considerations for placing the unit, including levelness and functional spaces.
Guidelines for pipes to optimize performance and minimize pressure drops.
Importance of water quality, acceptable limits, and filtration needs.
Steps for cleaning new and existing water systems before connection.
Specifies voltage, frequency, and phase balance requirements for the unit.
Details on earth connection and protective conductor cross-sections.
Steps and verification points for safe and proper unit start-up.
Pre-power checks, leak tests, and initial operational sequences.
Explanation of the control panel display, keys, and status indicators.
Procedures for changing unit state and adjusting cooling setpoints.
Setting weekly schedules and handling unit alarms.
Principles for performing unit maintenance and recommended intervention schedules.
Table detailing inspection tasks and their recommended frequencies.
Kit codes, dimensions, and diagrams for antivibration mount selection and installation.
Steps for safely disconnecting the unit and recovering refrigerant/fluids.
Guidelines for proper disposal of electrical and electronic equipment.
Identification of danger zones and risks associated with unit handling.
Risks from incorrect installation, leaks, and contact with unit components.
Tables of cooling and heating performance parameters for various models.
Details on compressor type, capacity, oil, and exchanger types.
Standard connection sizes and power supply details.
Sound power and pressure levels for ST configuration.
Sound power and pressure levels for EN configuration.
Graphical representation of standard and brine unit operating ranges.
Exchanger pressure ratings and safety device calibration setpoints.
Performance data for HWT models in cooling and heating modes.
Compressor and exchanger details for HWT models.
Sound data for HWT units in ST and EN configurations.
Graphical representation of HWT unit operating ranges.
Unit layout, mounting points, and weights for sizes 120.1-160.1.
Unit layout, mounting points, and weights for sizes 200.1-220.1.
Unit layout, mounting points, and weights for sizes 240.1-270.1.
Unit layout, mounting points, and weights for size 290.1.
Unit layout, mounting points, and weights for sizes 250.2-280.2.
Unit layout, mounting points, and weights for size 320.2.
Unit layout, mounting points, and weights for size 360.2.
Unit layout, mounting points, and weights for sizes 400.2-540.2.
To Next Page