When the cursor is on OPERATE FLOOR DRYING?
Use UP DOWN to scroll to YES and press OK.
The page will be displayed as follows:
During floor drying, all the buttons except OK are invalid.
When the heat pump malfunctions, the floor drying mode will
turn off when the backup heater and additional heating
source is unavailable.
If you want to turn off floor drying up, please press OK.
The following page will be displayed:
The target outlet water temperature during floor drying up
described in the picture below:
The AUTO RESTART function is used to select whether the
unit reapplies the user interface settings at the time when
power returns after a power supply failure.
How to set the auto restart
Go to MENU > FOR SERVICEMAN > AUTO RESTART
If the auto restart function is enabled, when power returns
after a power supply failure, the AUTO RESTART function
reapplies the user interface settings at the time of the power
supply failure.
To Next Page
Loading...
