go green pay less no mess
1. RECEIVING THE SHIPMENT.
Your Clivus Multrum toilet system is shipped as an assembled compost
tank with most of the Clivus components packed inside. All components
can be removed without disassembling the tank. The toilet chute will fit
through the inspection door. The pedestal package is usually strapped to
the compost tank.
Please refer to Section 3 and 4 to identify the components and check them
against the packing slip supplied. If there has been any damage, please
contact Clivus Multrum immediately on (07) 3889 6144.
Damage, shortages and discrepancies must be reported to your local
representative or Clivus Multrum Australia within 7 days of receiving
shipment. Any damage or missing parts not reported within 7 days from
receipt of goods will not be the responsibility of Clivus Multrum Australia.
2. INSTALLATION SUMMARY.
Read through the entire installation manual thoroughly before commencing
assembly.
» Ensure the tank is in a position so that all toilet chutes will
be vertical and over the tank in the preferred position/s.
» Ensure the tank is level, stable and supported.
» Mark and cut holes in the floor for the toilet chute(s).
» Mark and cut holes in the tank top.
» Insert toilet chute/s.
» Install pedestal/s.
» Install the vent system.
» Install the liquid end-product drain pipe and absorption/transpiration
trench.
» Connect fan to power source.
» Check everything is sealed.
» Place a starter-bed of bulking agent in the unit.
» Moisten bulking agent before use of toilet.
» Add starter bacteria after a short period of use.
PAGE 2
To Next Page
Loading...