go green pay less no mess
5. TOOLS & MATERIALS REQUIRED.
5.1 TOOLS REQUIRED:
» Spirit level
» Scissors or cutting knife
» Screwdriver (Philips head and plain)
» Jigsaw (an angle grinder or a drill can also be used to
cut large holes).
» Please use safety glasses.
» Dri l l
» Tape measure
» Caulking gun
» Felt tip or crayon marker
» Masonry drill and bit (if installing onto concrete floor)
» Spade
» Ladder
5.2 MATERIALS REQUIRED:
» Starter bulking material (if not purchased from Clivus).
See Section 14.
» Water for wetting starter material.
» Timber for tank rear support if required.
» Additional 40 mm PVC pipe, couplings and bends if
absorption trench is to be located some distance away
from tank.
» In poor soil conditions, extra length of trenching arch
may be required (500 x 230mm)
» Pipe bends if needed for vent pipe.
In addition, if the Vent & Drain Kit was not purchased with
your unit you will need:
» 150mm vent pipe lengths to suit (DWV class is
recommended).
» Vent pipe supports and wall/roof flashings to suit.
» 40mm DWV pipe and fittings to connect to a sullage
disposal system.
PAGE 6
To Next Page
Loading...