Cloer 7419 - Operation

10
EN
• Do not fill ingredients into stainless steel container
beyond the MAX mark.
• Very hard ingredients (e.g. seeds, ice cubes) and ex-
cessively moist foods such as apples, onions, etc. are
not suitable.
• Replace the stainless steel container lid and make
sure that the lid is properly seated.
• Note! The small cover must always be placed on the
stainless steel container for operation so that the
coupling is not damaged.
• Now place the stainless steel container back onto the
Motor unit.
• Now place the cover on the top interlock and turn it
anticlockwise until it clicks into place.
• Insert the plug into a socket.
• Manually press the desired grinding button on the
device.
• Release the switch when the desired degree of coar-
seness has been reached. The degree of coarseness
can be observed through the transparent cover.
• The upper grinding button grinds at low speed.
The lower grinding button grinds at high speed.
• Pull the plug out of the socket.
NOTE
Many types of food are best shredded in short bursts.
Additionally, interrupt operation regularly for a short
time. During the pauses, you can check whether the
desired grind has already been reached.
Do not remove the lid before the
grinding blades have stopped moving.
Danger of injury!
• Open the lid and turn the stainless steel container coun-
terclockwise to remove it and take out the Regrind.
Quantities and processing time
Some of our recommendations are listed below.
Food Level Quantity Container Time
Coffee
beans
1 5-80 g
2 bladad-
cutter
10-30 s
Almonds 1 10-80 g
4 bladad-
cutter
5-15
Impulses
Hazel-
nuts
1 10-80 g
4 bladad-
cutter
5-10
Impulses
Peanuts 1 10-80 g
4 bladad-
cutter
4-8
Impulses
Walnuts 1 10-40 g
4 bladad-
cutter
4-6
Impulses
Pine nuts 1 10-40 g
4 bladad-
cutter
4-5
Impulses
Flaxseed 2 10-80 g
2 bladad-
cutter
10-20 s
Technical Data
Typ Volt Hz Watt
741 220-240 50/60 350
Before the first use
Read these operating instructions
carefully before using the appliance
for the first time
• Remove all packaging elements and stickers, but not
the rating plate.
• Clean the appliance with a damp cloth
• Place the coffee grinder on a dry, flat, nonslip surface.
CE Label / Safety instructions
The appliance meets the requirements
of the applicable EC directives.
The appliance is designed for indoor
domestic use only.
ATTENTION! Always unplug the
appliance when not in use and
before cleaning.
NOTE
The mill is designed for short-term high power
milling with very high revolution speed. Stop
operation after 60 seconds and give the motor a
short time to cool down (approx. 5-10 seconds).
After three runs of 60 seconds, a longer break
(min. 2 minutes) should follow.
Operation
• Remove the bonnet, the lid and pour the grounds
into one of the two stainless steel containers.
• The 2-bladed cutter is suitable for grinding dry foods
and the 4-bladed knife for oily / moist foods.
The 2-bladed cutter is suitable for grinding dry foods
and the 4-bladed knife for oily / moist foods.
The 2-bladed cutter is suitable for grinding dry foods
and the 4-bladed knife for oily / moist foods.
Stainless steel container
with 4-bladed cutter
Stainless steel container
with 2-bladed cutter