10
EN
Technical Data
type volt hz watt
752 220-240 50/60 140-150
Before the first use
• Read these operating instructions carefully before
using the appliance for the first time.
• Remove all packing parts and possibly stickers, but
not the type plate nor the serial number.
• Clean the device with a moist cloth.
• Place the coffee grinder on a dry, slip-resistant and
level surface.
EC Label / Safety information
The appliance meets the requirements
of the applicable EC directives.
The appliance is designed
for indoor domestic use only.
ATTENTION! Always unplug
the appliance when not in use
and before cleaning.
Assembly
• To begin with, make sure that the appliance is not
connected to the mains and that the standby switch
8
is set to the OFF “O” position.
• Prior to assembly, ensure that the grinder is free of
any old coffee beans.
• Fit the grinding ring
1
incl. seal on the grinding
cone (below the coffee bean receptacle
5
. The three
teeth of the grinding ring will fit exactly into the three
notches in of the device. Beware! Sharp edges
• Attach the empty coffee bean holder
5
to the de-
vice. Do this by aligning the triangle on the coffee
bean holder with the grey mark on the appliance.
Now press the coffee bean holder down and turn it
clockwise towards the grinding coarseness setting.
• Please note that for safety reasons, your coffee
grinder will not function if the coffee bean holder
5
is not properly fitted.
• Now place the ground coffee receptacle with its lid
4
into position.
Operation
• Insert the plug into the socket.
• Select the desired coarseness
6
, by turning the cof-
fee bean holder
5
.
Hopper Insert Position
Adjust Position with Alternative Grind Level Settings
Original Silk Screen Printing (1:1)
Adjusted Silk Screen Printing (1:1)
Hopper Insert Position
Adjust Position with Alternative Grind Level Settings
Original Silk Screen Printing (1:1)
Adjusted Silk Screen Printing (1:1)
Hopper Insert Position
Adjust Position with Alternative Grind Level Settings
Original Silk Screen Printing (1:1)
Adjusted Silk Screen Printing (1:1)
Hopper Insert Position
Adjust Position with Alternative Grind Level Settings
Original Silk Screen Printing (1:1)
Adjusted Silk Screen Printing (1:1)
NOTE
The lower the number, the finer the degree of grinding.
The lower the number, the finer the degree of grinding.
• You can also use the cup number selector
2
for
pre-setting the grinding time.
2-12
• The grinder is optimised for filter coffee. A coarseness
setting between 7-9 corresponds to commercially availa-
ble ground filter coffee. The cup number selector (2-12)
is designed to grind approx. 5-7 g of coffee per cup. The
amount of ground coffee produced is also influenced by
other factors such as coffee type and moisture content.
• Pour coffee beans into the coffee bean holder
5
(max. 300 g).
NOTE Change coarseness setting
In case the coffee beans have already been added,
only adjust the coarseness setting.
• Set the power switch
8
to ON “I” to provide the elec-
trical supply.
To Next Page
Loading...