4
Getting Started
Modes
1. Begin by removing the Nimbus Unit and Power Adapter from
the packaging.
2. Locate a suitable location to place your unit. (Ideal location is an area of
the room with good circulation, or near the source of your pollutant.)
3. Plug the Power Adapter into a wall outlet and then plug the other
end into Power Port of your unit.
4. Press the Power Button to control to power of your unit.
NOTE: Your unit will start in Ionization Mode.
5. Press the Mode Button on the top of your unit to switch from
Ionization Mode → Purifier Mode → Burst Mode.
Ionization Mode (Idle Blue Light)
Ionization Mode is your unit’s default mode. This mode is ideal for removing airborne
particulates such as smoke, pollen, and pet dander from your breathing space.
Purifier Mode (Idle Red Light)
Purifier Mode creates Ozone and Ionization for a powerful 30 minute cycle before
reverting back to Ionization Mode.
NOTE: Ozone can cause skin and eye irritation. Keep room unoccupied when using Purifier Mode.
Burst Mode (Flashing Red Light)
Burst Mode repeats between 5 minutes of Purifier Mode and 25 minutes of Ionization Mode.
To Next Page
Loading...