To Next PageTo Next Page
Need help?Do you have a question about the CMI/MPH INTOXILYZER 5000 and is the answer not in the manual?
General| Sample Type | Breath |
|---|---|
| Measurement Range | 0.000 to 0.400 % BAC |
| Measurement Principle | Infrared Spectroscopy |
| Operating Temperature | 10°C to 40°C (50°F to 104°F) |
| Power Supply | 50/60Hz |
Alphanumeric display for operations, alerts, and results.
Switches to select modes, set time/date, perform diagnostics.
Microprocessor failed to get stable reference.
Requesting subject to blow until tone stops.
Intermittent tone for malfunctions or errors.
Mode sequences for the five-mode option.
Mode sequences for the four-mode option.
Enables attachment/detachment of collector device.
Enables setting the displayed time.
Enables setting the displayed date.
Scrolls all displayable characters.
Prints characters and transistor numbers for malfunction diagnosis.
Step-by-step guide for ABA test sequence.
Displaying subject's alcohol concentration.
Example of printed output.
Example of evidence card for failed checks.
Steps for control check within ACA sequence.
Diagrams and instructions for using the TOXTRAP tube.
Initial status and diagnostic checks.
Lists error messages and corrective actions.
Locating instrument for clearance and ventilation.
Fuse and power cord are user-serviceable.
Setting the instrument's time.
Setting the instrument's date.
Explains switch priority logic.
Steps to get a printout of diagnostic checks.
Example of evidence card for passed checks.
Example of evidence card for failed checks.
Operations for custom sequence with sample capture.
Operations for control sequence without sample capture.
Analyzes alcohol vapor from simulator.
