GB
41
– Remove the saw blade from the motor
shaft and carefully remove by taking
downwards.
Fitting a saw blade
– Clean all pieces to be mounted before
installation.
– Put the new saw blade into place.
– Fit the tensioning flange (10).
– Fit the washer.
– Screw the tensioning screw (11) into
place using the supplied mounting wrench
and turning in an anti-clockwise direction.
Troubleshooting
What to do when something doesn’t
work…
Malfunctions are often caused by minor
faults. You can easily remedy most of these
yourself. Please consult the following table
before contacting the vendor. You will save
yourself a lot of trouble and possibly money
too.
If you can’t fix the fault yourself, contact your
nearest vendor. Please be aware that any
improper repairs will also invalidate the war-
ranty and additional costs may be incurred.
Disposal
Disposal of the appliance
A crossed-out wheelie bin icon
means: Batteries and rechargeable
batteries, electrical or electronic
devices must not be disposed of with
household waste. They may contain
substances that are harmful to the environ-
ment and human health.
Consumers must dispose of waste electrical
devices, spent portable batteries and
rechargeable batteries separately from
household waste at an official collection point
to ensure that these items are processed cor-
rectly. Information on returning these items is
available from the seller. Sellers are required
to accept these items free of charge.
Batteries and rechargeable batteries,
which are not permanently installed in
waste electrical devices, must be
removed prior to disposal and must be
disposed of separately. Lithium batteries and
battery packs in all systems must only be
DANGER! Risk of injury! The ten-
sioning screw may not be tightened
too far. This may cause damage to the
unit and serious injury!
Remove the mounting wrench before
turning the power tool on. A wrench or
a key left attached to a rotating part of
the power tool may result in personal
injury.
WARNING! Risk of injury! When
installing, ensure that the saw blade
sits correctly on the motor shaft. Oth-
erwise the saw may block or the saw
blade come undone!
NOTICE! Risk of damage to the
unit! Make sure that the saw blade is
installed in accordance with the rota-
tion direction of the blade! The arrow
direction on the saw blade and the
unit must match.
DANGER! Danger to life and limb!
Unprofessional repairs may mean that
your unit will no longer operate safely.
This endangers you and your environ-
ment.
Error/Fault Cause Remedy
Device does not work No power supply? Check the cable, plug, and the
fuse.
Is the device defective? Contact your local vendor.
Sawing performance is not
good enough.
Saw blade is blunt? Replace the saw blade
( Changing the saw blade –
p. 40).
Saw blade not suitable for the
materials?
Saw blade distorted?
Saw vibrates heavily.
Saw blade mounted incorrect-
ly?
Mount saw blade correctly
( Fitting a saw blade –
p. 41).
To Next Page
Loading...
Need help?
General
