53
Filling up saw chain oil
►P.5, item8
– Lay device securely with the tank
cover(10) upwards.
– Before opening, clean the tank cover and
the filler neck if necessary.
– Slowly open and remove the tank cover.
– Carefully fill up the saw chain oil. Do not
spill!
– Read the oil level at the inspection
glass(6). The oil stand must be placed
between[MIN] and[MAX].
– Tighten the tank cover by hand.
– If you have spilled any saw chain oil, be
sure to wipe it up.
Operation
Safety equipment
The device has several pieces of safety
equipment which reduce the risk of injury
when working:
Chain catcher
The chain catcher serves to catch a torn saw
chain or one which has jumped out of the
guide. Through regular maintenance of the
saw rail and correct and regular tensioning of
the saw chain, accidents of this type can be
prevented.
Rear hand guard
The rear hand guard serves to protect the
hand against a jumped chain and disturbing
branches and twigs.
Check before starting!
Check the safety equipment and the safe
condition of the device.
– Check all parts for their firm fit.
– Check whether there is any leakage.
– Check whether there are visible defects:
broken parts, cracks, etc.
– Check the device for correct chain ten-
sioning.
– Check the function of the chain brake.
Attaching the extension cable
►P.5, item9
– Plug the unit plug into the connector of
the extension cable.
– Feed the extension cable through the
strain relief mechanism(13) as shown.
Starting the device
►P.5, item10
– Hold the device fast with both hands.
– The hand guard(8) must be folded
towards the back.
– Press the switch-on safety lock(11).
– Press the start button(12).
The device starts up.
Use
Before use, familiarize yourself sufficiently
with the sawing technique for chain saws.
You will find information about this in the
NOTICE! Environmental damage!
Since the saw chain oil can penetrate
the environment during operation,
biologically-degradable special veg-
etable-based saw chain oils should
be used.
DANGER! Risk of injury! The
device must only be put into opera-
tion if no faults are found. If any part
of the device is defective, it must be
replaced before the next use.
GB
Kettensaege_Elektro_302128.book Seite 53 Donnerstag, 5. Januar 2017 4:59 16
To Next Page
Loading...
Need help?
General
