CMS TX050 - Confirming and Setting Other Parameters; Confirm Unit Setting; Setting Additional Parameters

Autore Fausto Zanardi C:\DATI\WORD\Refrigeratori\TexaProgTermFTX050.doc pag 2
1.07 Hit the button to confirm
1.08 Wait until the unit quits the parameters’ area (around 10 seconds)
1.09 press simultaneously the buttons:
and
Keep them pressed as long as (around 7 seconds) to get the parameter
H
H
y
y
1.10 Release the buttons than press them again as long as to get the word
L
L
2
2
1.11 Release the buttons,
The Display shows parameter
H
H
y
y
1.12 Select parameter
U
U
S
S by playing on button or button
1.13 Set its value according to the following list
1.14 Following the same method set the parameter
L
L
S
S
1.15 Following the same method go on setting all the other parameters except the parameter
S
S
E
E
T
T
1.16 At the end, wait until the unit quit the parameters’ area (around 10 seconds).
The Display shows the cabinet’s temperature
1.17 Hit the button
The Display shows the SET’s value
1.18 Alter the value according to the list