Why does my CMT ORANGE TOOLS CMT7E run or cut slowly?
If your CMT ORANGE TOOLS Wood Router runs or cuts slowly, it might be due to a blunt or damaged cutter. Try re-sharpening or replacing the cutter. Also, check if the Speed Controller is set low and increase the variable speed setting. The motor could also be overloaded, so reduce the pushing force on the router.
What to do if my CMT ORANGE TOOLS CMT7E Wood Router will not operate?
If your CMT ORANGE TOOLS Wood Router is not operating, first ensure that power is available at the source. Then, disconnect the power, open the Brush Access Covers, and check the brushes for damage or heavy wear. If the switch is faulty, have the tool serviced by an authorised CMT service centre.
How to fix excessive vibration in my CMT ORANGE TOOLS Wood Router?
Excessive vibration in your CMT ORANGE TOOLS Wood Router can be due to an incorrectly fitted or loose router bit. Try refitting or tightening the router bit. It could also be caused by a bent or damaged router bit, in which case you should replace it.
What causes heavy sparking in my CMT ORANGE TOOLS CMT7E Wood Router motor?
If you experience heavy sparking inside the motor housing of your CMT ORANGE TOOLS Wood Router, it could be that the brushes are not moving freely. Disconnect the power, remove the brushes, and clean or replace them. If the motor is damaged or worn, have the tool serviced by an authorised CMT service centre.
How to correct an inaccurate cutting profile with my CMT ORANGE TOOLS CMT7E?
If your CMT ORANGE TOOLS Wood Router is producing an inaccurate cutting profile, ensure that the Depth Stop corresponds to the maximum amount of cut permitted by the Turret Stops. Also, check if the router bit/Collet is incorrectly fitted or loose, and tighten the router bit/Collet and cutter assembly.
What to do if the Micro Winder on my CMT ORANGE TOOLS Wood Router clicks or won't adjust?
If the Micro Winder on your CMT ORANGE TOOLS Wood Router 'clicks' or is not adjusting, first make sure the Plunge Lock Lever is released. If that's not the issue, you may have reached the end of the adjustment range. Reset the Micro Winder and set the depth using the Depth Stop.
Why my CMT ORANGE TOOLS CMT7E has no function when the power switch is on?
If your CMT ORANGE TOOLS Wood Router has no function when the On/Off Power Switch is operated, first check the power supply. If the power supply is OK, the On/Off Power Switch may be defective and should be replaced at an authorised CMT service centre.
General| Brand | CMT ORANGE TOOLS |
|---|---|
| Model | CMT7E |
| Category | Wood Router |
| Language | English |
To Next Page
