1. BUTTONS AND LCD DISPLAY
2. MEASURING IN ABSOLUTE (ABS) MODE
3. USING A HIGH QUALITY LEVEL VIAL
4. ANALOGUE QUADRANT FOR MOVING BLADE
5. LOCKING YOUR DIGITAL ANGLE FINDER FOR MEASURING
ON
OFF
HOLD
ZERO
ABS
A. ABS mode.
B. Press longer than eight seconds to turn your device off;
short press to turn LCD off.
C. Records the last measured value.
D. Switch between absolute and relative measuring mode
by short pressing the button.
E. High resolution: 0.05°
F. Analogue quadrant showing.
Under ABS mode,
press ZERO/ABS
for five seconds
to set the moving
blade to zero.
Place the moving blade in the same
position of the fixing blade.
Standard level surface.
Make different measuring by locking at four different locking holes.
Notice: measuring range can reach 360° after screwing off the locking knob.
Measuring range: -45° ~180° Measuring range: 0° ~225°
Measuring range: -180° ~45° Measuring range: -225° ~0°
Plumb surface
for measuring.
(1) Device automatically
resets to the original zero
position after shutting off.
(2) Device even makes
upright measurements.
Under ABS mode
- Position in the quadrant: 45°.
- Display range of quadrant is 360°.
-45°
45°
0°
-0.05°
45.05°
0.05°
90°
DIGITAL
ANGLE
FINDER
DAF-001
DIGITAL
ANGLE
FINDER
www.cmtorangetools.com
Clean digital angle finder with mild
liquid soap and a damp cloth.
Never dip into water.
Don’t mark bar with any electric
engraver or scratch it.
DAF-001
1. Metal moving blade
on the front.
2. Aluminium fixing blade.
3. LCD display.
4. Locking knob.
Four holes for locking when measuring
specific angles. Measuring range can reach 360°
after screwing off the locking knob.
Lock the moving blade
at any angle, make precise
drawings and cut directly.
Holes for locking.
Analogue quadrant
showing.
PowerHigh Resolution
3V CR2032
lithiun battery
B C D
03.55.0135 VERS-2022-06
Imported by
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
21
PAP
BATTERY
INCLUDED
(CR2032-3V)
INSTRUCTION
EN ES FR IT DE PL RU
To Next Page
Need help?
General