6.Click “Next” to pop up the “Target Image” dialog box, where you can set the engraving speed, minimum power and
maximum power and the length and width of the image to be engraved and offset. Click “Create” after setting.
Move to the position you want to engrave, click the “Position” button (the position where the laser head is located at
the lower left corner of the engraved pattern), set the number of times to be engraved, and click the “Start Engraving”
button to start the engraving. After the engraving is completed, the machine returns to the zero position.
7.After clicking "Create", enter the preparation for engraving.
To Next Page
Loading...
Need help?
General
