2
ENGLISH
Belt & Disc Sander
Art. no 18-3206 Model MM1510A-UK
40-8043 MM1510A
Please read the entire instruction manual before using the product and save it for future reference.
We reserve the right for any errors in text or images and any necessary changes made to technical data.
If you have any questions regarding technical problems please contact Customer Services.
1. Safety
1.1 General safety instructions for your safety and the safety of others
1. Keep the working area tidy. Cluttered surfaces and benches invite accidents.
2. Do not use the machine in dangerous environments. The machine should not be used on moist or wet
surfaces or in rain. Make sure that the work area is well lit. When working in dusty atmospheres, make sure
that the air is adequately circulated. Do not operate power tools in explosive atmospheres, such as in
the presence of flammable liquids, gases or dust.
3. Avoid electric shocks. Avoid body contact with earthed or grounded surfaces such as pipes, radiators,
ranges and refrigerators when using power tools.
4. Keep children and bystanders away. Keep children and visitors at a safe distance from electrical
machinery/tools and electric cables in the workplace.
5. Store power tools out of the reach of children. When not in use, power tools should be stored locked
away in a safe place, away from children.
6. Do not force the machine. The correct feed rate makes the work better and safer.
7. Use the correct tool for the job. Do not force a tool to perform a task that it was not designed for.
8. Wear suitable attire. Do not wear any loose-fitting clothing, gloves, necklaces, bracelets or other jewellery
that can get caught in moving parts. Non-slip footwear is recommended. Wear a hairnet or similar if you
have long hair.
9. Always wear safety glasses. Normal glasses are not tough enough to withstand impacts. Use a dust
mask or dust filter when working in dusty environments.
10. Connect dust extraction equipment. If the machine is equipped with facilities for removing dust and
sawdust, make sure that the facility is used correctly and emptied regularly.
11. Do not abuse the lead. Do not carry the machine by its mains lead. Do not use the mains lead to pull or
unplug the power tool, pull the plug out instead. Make sure that the mains lead does not come into contact
with heat, oil, or sharp edges.
12. Secure the workpiece firmly. Where possible, use clamps or a vice. You can then operate the tool using
two hands. This is much safer than holding the workpiece in one hand.
13. Do not overreach. Make sure that you stand steady and balanced all times.
14. Look after you tools. Make sure that they are clean and that the edges are sharp for maximum effect and
best results. Follow the manuals recommendations regarding lubrication and replacement of accessories.
If it is damaged it should be replaced by a qualified service technician. Inspect all leads and cables regularly
to check for any damage. Make sure that the machine’s handles and controls are clean, dry and free from
oil and grease.
15. Turn the power off. Pull out the plug and push in the emergency stop button before servicing or changing
any blades, drill bits, cutters or sanding discs.
16. Remove all spanners and repair tools. Make a habit of checking to make sure that the machine is free of
all spanners and tools before turning the power on.
17. Avoid accidental starts. Do not walk around with your finger on the trigger of a power tool if it is plugged
in. Make sure that the on/off switch is set to OFF before plugging in any power tool.
18. Use the correct extension leads. If you use extension leads outdoors, only use those designed for
outdoor use. Only use extension leads with adequate wire core area and roll out the whole lead.
19. Use common sense and be careful. Think carefully before carrying out every action, so that it is carried
out safely. Never operate machines/power tools when you are tired or under the influence of medicine.
To Next Page
Loading...
General