To Next PageTo Next PageWhy does the wood start to smoke when sanding with the CO/Tech MM1510A-UK Sander?
If the wood starts to smoke during sanding with your CO/Tech Sander, it's likely because the sandpaper or belt has become smooth or clogged with sap. The suggested solution is to change the sanding disc paper or belt.
What to do if my CO/Tech Sander slows down when sanding?
If your CO/Tech Sander machine slows down when sanding, it's likely because too much pressure is being applied to the workpiece. Try applying less pressure during sanding.
How to fix the sanding belt that keeps coming off my CO/Tech MM1510A-UK?
If the sanding belt keeps coming off your CO/Tech Sander, it's due to incorrect tracking. To resolve this, adjust the tracking.
How to troubleshoot a CO/Tech MM1510A-UK Sander when the motor does not start?
If the motor of your CO/Tech Sander does not start, it could be due to a defective switch or power supply. The suggested solution is to replace the defective part before commencing work.
General| Sander Type | Random Orbital Sander |
|---|---|
| Power | 300W |
| Voltage | 230V |
| No Load Speed | 12000 rpm |
| Sanding Pad Size | 125mm |
| Dust Extraction | Yes |
| Weight | 1.5 kg |
| Power Source | Corded |
Comprehensive safety guidelines for operating the machine and ensuring user safety.
Crucial safety rules and precautions specifically for using belt sanders.
Step-by-step guide for installing or replacing the sanding disc paper.
Instructions on how to fit or replace the sanding belt on the machine.
Procedure for attaching and adjusting the side table for various uses.
Guide on setting up and using the side table for belt sanding operations.
Instructions for attaching and securing the work stop component.
How to adjust the sanding belt for optimal alignment and tracking.
Steps for positioning the sanding belt at different operational angles.
Explanation of the combined power and no-volt release switch functions.
Guidance on properly positioning and securing the sander for safe use.
Sanding workpieces at angled positions using the adjustable side table.
Techniques for surface sanding using the belt, horizontally or vertically.
Using the side table to support long workpieces for end sanding.
Methods for sanding inside and outside radius curves on the machine.
