4
With the chamber flap closed, insert
the code strip as far as it will go and
remove it immediately.
5
Successful coding is confirmed by a
short beep (if the beeper option is
enabled) and the code is displayed
by the meter. If an error occurs or if
the code is not displayed, repeat
the process after a few seconds.
3
Insert a code strip as shown. Do not
touch the printed area behind the black
bar or on the back of the strip.
If no code has ever been stored,
codenr flashes with three dashes.
Otherwise the last stored code is
displayed.
You must code the meter
every time you open a new
test strip container.
To Next Page
Loading...
Need help?
General