®
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180 Fax. 714.692.5016
www.cobrausa.com
04/17
®
*Cobra® recommends you always wear a helmet while riding. Please never operate your motorcycle while under
the influence of alcohol and/or drugs. Enjoy the new look of your motorcycle and please ride safely.
1 – Chrome Regulator Cover
2 – Screws, M6 X 12 mm Buttonhead Stainless Steel
Kawasaki VN900 2006 - 2019
1. Remove the stock bolts and regulator cover from the motorcycle, none of these components will be
reused.
2. Place the new chrome cover into the position where the original Kawasaki cover was located and align
the holes in the part with those on the regulator. Insert the supplied M6 x 12mm screws and prior to
tightening the screws fully align the cover with the radiator or radiator cover if purchased, above it.
3. Once the cover has been aligned tighten the screws to factory specifications.
To Next Page
Need help?
General
