Setting Dynamike
This controls the microphone sensitivity
(outgoing audio level).
To Transmit
21
To Transmit Transmit
20
Setting
Dynamike
Caution!
Be sure the antenna is properly
connected to the radio before
transmitting.Prolonged trans-
mitting without an antenna,or
a poorly matched antenna,
could cause damage to the
transmitter.
Be sure to read the F.C.C.Rules
and Regulations included with
this unit before transmitting.
Operation Operation
1
Select desired channel.
1
Initially, set fully clockwise so that maxi-
mum voice volume is available.Dynamike
may have to be reduced in some conditions.
Transmit
Push and hold mic button to transmit.
Transmitter is now activated.When transmit-
ting,hold the microphone two inches from
your mouth and speak in a clear, normal voice.
Release to receive.
1
29 WX NW ST manual 3.3 6/15/99 2:53 PM Page 20
To Next Page
Loading...
