Twist the back shell in an anti-clockwise direction and pull it off.
The bulb can now be removed from the rear of the reflector.
Place the replacement bulb in the holder, taking care to locate it
correctly. Engage the projections on the inside of the back shell with the
slots in the holder, press on and secure by twisting it to the right.
LIGHT UNIT
VERTICAL SETTING
ADJUSTMENT SCREW
(
DUST EXCLUDING
RUBBER
BULB HOLDER
HORIZONTAL SETTING
ADJUSTMENT SCREWS
Position the Light Unit so that the heads of the adjusting screws
protrude through the slotted holes in the flange, press the unit
in
and
turn in a clockwise direction. Replace the rubber ring so that the thicker
inner edge rests in the recess around the Light Unit rim.
Refit the front rim, locating the top of the rim first and secure by
means of the fixing screw.
HEADLAMP SETTING
(
The lamps should be set so that the main driving beams are parallel
with the road surface and with each other. If adjustment is necessary,
remove the front rim and dust excluding rubber as described above and
trim each lamp to the correct position by means of the three spring loaded
adjustment screws.
The setting of the lamps can be carried out by placing the car in
front of a blank wall at the greatest possible distance, taking care of course
that the surface on which the car is standing is not sloping relative to the
wall.
Cars fitted with sealed beam headlights are adjusted in this manner
with two set screws which are exposed when the lamp rim is removed.
51
To Next Page
Loading...