Cobra ESD-9210 - Alert Audio Setting; Voice;Tone Setting

3
OPERATION•SETTINGS
3
OPERATION•SETTINGS
Voice/Tone Setting
You can set your ESD-9210 to sound alerts
with either a voice or a tone. You change
settings by using the MUTE button.
In Voice Alert™ mode you will first hear
several tones, then a voice message
announcing the type of signal detected,
followed by more tones. In Tone Alert
mode, you will hear the tones only.
The factory setting is Voice Alert™ mode .
13
12
MUTE button
Press and hold for 2 seconds
VG-2 Alert
®
Audio Setting
The ESD-9210 is undetectable by police
VG-2 detection devices, and will alert you
when such a device is in use near your
vehicle. During the alert, the unit continues
to detect other signals. You can choose
whether or not you want your unit to
sound VG-2 alerts.
The factory setting is VG-2 Audio On.
X K Ka V S
DIM button
Press and hold for 2 seconds
To change from
Voice Alert™
to Tone Alert
To change from
Tone Alert back
to Voice Alert™
Procedure
While no signal is
being detected,
press and hold the
MUTE button for
two seconds.
While no signal is
being detected,
press and hold the
MUTE button for
two seconds again.
Tone
1 beep
none
Voice
”tone alert“
”voice alert“
Visual Display
none
none
To turn off
VG-2
audio alert
To turn on
VG-2
audio alert
Procedure
While no signal is
being detected,
press and hold
the DIM button
for two seconds.
While no signal is
being detected, press
and hold the DIM
button for two
seconds again.
Tone
1 beep
2 beeps
Voice
”VG-2
audio off“
”VG-2
audio on“
Visual Display
V
will blink
once in
the display
V
will blink
twice in
the display.