Cobra LT102HRL - Fitting the Steering Wheel

12
15. Grass-catcher component
① Cover;
② Top frame weldment;
③ Layer board;
④ Grass bag;
⑤ Front bracket;
⑥ Side stay pipe;
⑦ Overturn lever;
⑧ Nuts, bolts;
⑨ Swivel bracket (R);
⑩ Swivel bracket (L)
16. Rear baffle plate component.
To prevent damage to the cutting deck, raise it to its
maximum height and take utmost care when taking the
machine off the pallet.
3.2 FITTING THE STEERING WHEEL
Put the machine on a flat surface and straighten up
the front wheels.
a. Fit the shaft (1) onto the couplings and tightening the
screw M8x25 (2). (Use the hex wrench 5 in accessories
tools.)
b. Fit the steering shaft cover (3).
c. Inset the splined hub (4) to shaft (1), mounting
steering wheel (5), spacer (6) and tightening nut M8
(7).(Use the open end wrench 13-15 in accessories
tools.)
d. Inset the steering wheel cover (8) into steering wheel
and tightening two screws (9). (Use the cross
screwdriver in the accessories tools.)
NOTE
Pay attention to the direction when mounting the
steering wheel .