13
Only for LT86MRL (TTM86M) Manual Transmission
Put the machine on a flat surface and straighten up the
front wheels.
a. Fit the shaft (1) onto the couplings and tightening the
screw M8x25 (2).
(Use the hex wrench 5 in accessories tools.)
b. Fit the steering shaft cover (3).
C. Fit the steering wheel 4 onto the steering shaft ,
insert screw (5) and tighten it by nut (6).
3.3 FITTING THE SEAT
Mount the seat on the plate using the screws.(Use the open
end wrench 8-10 in accessories tools.
For optional seat only (if applicable):
a.
Fix the right armrest (1) on the seat with three M8 screws
(2) using the Allen wrench in accessories tools, and fix
the left armrest (3) on the seat in the same way;
b.
Snap the retaining ring (1) into the pin (2), use the pin to
link the seat (3) to the bracket, and snap it into the
retaining ring (4).
To Next Page
Loading...