Remove Belt Clip
Pull Up Lock Latch
Insert Batteries
Radio Charger Jack
Operation Customer Assistance Warranty
Introduction
Caring for Your microTALK
®
Radio
•
Your microTALK
®
radio will give you years of trouble-free service
if cared for properly. Handle the radio gently. Keep the radio away from
dust. Never put the radio in water or in a damp place. Avoid exposure to
extreme temperatures.
Rechargeable Batteries and Charger
•
To install or replace batteries:
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
2. Pull up on the battery door latch to remove the
battery compartment cover.
3. Insert the supplied four AAA rechargeable
batteries or non-rechargeable alkaline batteries.
Position batteries according to polarity markings.
4. Replace battery compartment cover and
belt clip.
To charge batteries in radio:
1. Check to see that the batteries have been
inserted properly.
2. Insert the wall charger/adapter into the charge
jack located at the top of the radio. The wall
charger/adapter has two round connectors which
enables you to charge either one or two radios at
a time.
3. Plug the wall charger/adapter into electrical
outlet.
It normally takes 15 hours to fully recharge batteries. It is not
recommended to recharge batteries more than 24 hours. Estimated
operation time on a full charge is 8 hours.
Use only the supplied rechargeable batteries and wall charger/adapter
for recharging your Cobra microTALK
®
radio.
1
Nothing Comes Close to a Cobra
®
To Next Page
Loading...
Need help?
General
