Cobra microTALK FRS 110 - Operation: Battery Installation; Battery Installation Guide; Operation: Turning On and Display; Turning On Your microTALK

Push and hold the POWER button for
2 seconds.An audible “tone”will indicate the
unit is on.
Operation
3
Turning On Your microTALK®
Note
Whenever the unit is on
you can receive
communications.
Turning
On Your
microTALK
®
Illuminating the Display
Illuminating
the Display
1
1
Push and release LIGHT/MAX RANGE
button to illuminate display for ten seconds.
Pull lock tab down
to remove battery
cover.
Insert four “AAA”
batteries.Position
batteries according
to po l a ri ty marki n g s.
Operation
2
Note
Always use high quality
a l caline batte ri e s.
When batte ries are low the
i n d i ca tor will blink.
Install Batteries
Battery
Installation
1 2