Operation
9
Operation
8
Note
Your incoming “Call” signal
level is dependent on your
unit volume setting.
Talking To
Another Party
Push and release CALL button.The unit you
are calling will hear a two second ringing tone.
3
Talking To Another Party
Push and hold
TALK button.
1
The TX indicator will
be displayed.
2
Hold mic about
2 inches from
mouth. Speak in a
normal voice.
3
Release TALK
button and listen
for response.
4
Note
While the TALK button
is depressed you cannot
receive incoming calls.
Roger Beep
Confirmation
Tone
Listening For Another Party
When finished talking:
Listening For
Another Party
Release TALK button to receive incoming
transmissions.
Your microTALK® is always in listening mode
when the TALK button is not pressed.
Adjust volume by pushing
DOWN/UP buttons.
1
Note
While the TALK button
is depressed you cannot
receive incoming calls.
Your listener will hear an
audible tone when you
release the TALK button.
This alerts the other party
that you are finished talking
and it’s OK for them to begin
talking.
Roger Beep Confirmation Tone
2
To Next Page
Loading...
