9 | P a g e
RADAR ALERT SETTINGS
The detector allows you to choose whether it will show alerts on the X, K and Ka Bands. The
factory settings are: X, K, and Ka On.
To Turn X Band On and Off
While no signal is being detected, press and hold both the DIM and MUTE buttons for four
seconds.
X Off = One beep and X flashes once
X On = Two beeps and X flashes twice
To Turn K Band On and Off
While no signal is being detected, press and hold both the SEN and MUTE buttons for four
seconds.
K Off = One beep and K flashes once
K On = Two beeps and K flashes twice
To Turn Ka Band On and Off
While no signal is being detected, press and hold both the SEN and DIM buttons for four
seconds.
Ka Off = One beep and Ka flashes once
Ka On = Two beeps and Ka flashes twice
DETECTION
The following tables show you the types of signals your detector will detect, and the visual
alerts for each.
AUDIO ALERTS
A distinctly different Alert tone is used for each type of signal detected (including separate
tones for each laser signal). For X, K and Ka band radar signals, the tones will repeat faster as
you approach the signal source. The repeat rate of the tones gives you useful information about
the signal detected.
To Next Page
Loading...
