I.
Plug
in the AC
power
plug.
2.
Set
the function
switch
to CD position.
3.
Press
POWER
button
to turn on the unit.
4.
Open
the CD cover by
press
CD cover button.
5.
Insert
a CD disc in the CD
compartment
with
the label side
facing upward.
6. Close the CD cover by
gently
pressing
CD
cover
securely
till
it clicks.
7
.ADJUSTING
THE
SOUND
"
• Press the volume +/-
buttons
to
set
the
sound
level.
•
For
increased
bass at all
volume
levels,
switch
the BASS
SWITCH
on to
boost
the low frequency sound.
8.
Press
PLAY/PAUSE
button
~lIto
start
playing
from the first
Track.
• Press
~II
during
playback
to
pause
temporarily.
• Press
~II
again to resume
playback
from the
point
playback
is interrupted.
9.
Press
and release the SKIP
button
I+l or~ to
search
backward
or forward to the
desired
track.
10.Press and hold the
SKIP
buttonjee
or~ to
search
backward
Or forward to the
desired
point
of
the
playback
or track.
II.
Press the STOP
button.
to stop playing,
12. In STOP mode,
press
PROGRAM
button
PROG
to
start
the
memory
function.
Press
I+l or
~
to select the
desired
track
numbers,
press
PROG
again
to store the
desired
tracks.
Repeat
this
operation
to
memorize
up to a total
of20
tracks.
Pressj-Il
to start
playing
the tracks in the
order
programmed.
To cancel
memorized
tracks,
press.
and open the CD
cover
by
press
CD cover
button.
13.
Press
REPEAT/RANDOM button to
repeat
function. Press
REPEAT
/RANDOM
button
once to repeat the
same
track
only,
and the "REPEAT"
display
will
light
up and flash. Press the
REPEAT/RANDOM
button
twice
to
repeat
all, and the "REPEAT"
display
will light up
and
not flash. To
cancel
repeat
play, press the
REPEAT /RANDOM
button
twice until the
repeat
indicator
disappeared.
14.
Press
REPEAT/RANDOM
button
to
select
random
mode
until
"
RANDOM
appear. All the tracks on the
loaded
CD
will
be
played
in
random
order.
Playback
will stop
automatically
when all tracks
have
been
played. To
cancel
repeat
play,
press
the REPEAT/
RANDOM
button
until
RANDOM
disappear.
IS.CDDISPLAYWINDOW
8
@®nD
fIYj]~fIYj]@1K&
t1?LAY
~~Mo.O[]o.o
0.0
~~~~[]O~[]~=
~~[Q)@~~~~'D'
"iLl
---~;!'I'!:
1. Clean your unit with a
damp
(never wet) cloth, Solventor detergentshould
never be used.
2. Avoid ieaving your unit in direct sunlight or In hot, humid or dusty places,
3, Keep your unit
away
from heating appliances and sources of electrical noise
such as fluorescent lamps or motors,
4. If crop-outs a lntenupllors occur
10
the
rnusl
I
~
I
during play, or if the disc failsto play at all, its
bottom
surface
may
require cleaning. Before
playing, wipe the disc from the center outwards with
a
good
soft cleaning cloth.
____
..
_lIifiN~imr
This
equipment has been tested and found to comply withthe limitsfora ClassB
Digital Device, pursuant to Part 15 of the FCC
Rules.
Theselimitsare designed
to provide reasonable protection against harmful interference in a residential
installation.
This
equipment generates, usesand can radiate radio frequency
energy and, if not installedand used in
accordance
withthe instructions,
may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not
occur
in a particular installation. If this
equipment does cause harmful interference to radio or television reception.
which
can
be determined by turning the equipment
off
and on, the useris
encouraged to
try to correct the interference by one or more of the following
measures:
- Reorientor relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outiet on a circuit different from that to which
the receiver isconnected,
- Consultthe dealeroran experienced radio technician for help,
9
To Next Page
Loading...
Need help?
General
