Coccolle corso - Page 16

EN
1. Parts name
A.Frame
B.Front fork
F-4.∮8 shim
Step 2
N.Fender
J.Pushbar (up)
Q-1.Cup
Step 5
2.Insert the handlebar (G)into the front fork(B).then tighten them up with M5*35 screw (3N*M)
until hear “click”.
3.Fix the Seat Fixture(P) into the seat (O)with M8*110 screw(F-3)(5N*M) and∮8 shim.
Then insert the seat onto the frame(A). last tighten them up with M8*38 screw(F-2) (3N*M).
1.Insert the fender(N) into the front fork(B).then tighten them up with screw(3N*M).
E.Pushbar (bottom)
F-1.M8*38 screw
H.Back rest
K.Canopy
P.Seat Fixture
Q-2.Brake parts 2
1.Insert the front wheel into the frame(A).then tighten them up with 25mm fastening ring(F-2).
1.Insert the back rest(H) into the seat(O) until hear “click”.
2.Take off the screw and plastic on the foot rest(L).then insert the foot rest into the downside of
the frame(A),last tighten them up with screw and plastic(3N.M).
O.Seat
Step 3
D.Front wheel
F-2.M8*110 Screw
C.Rear wheel
L.Middle foot rest
F-3.5M-6M wrench
M.Rear axle
R.Front foot rest
G.Handlebar
2. Assemble step
Step 1
2.Take off the screw on the front wheel(D),then insert the front fork(B) into the front
wheel(D).last tighten them up with screw(5N*M).
I.Rear basket
1.Loose the screw under the frame(A).then insert the brake(Q-2).shim.rearwheel(C).
rear axle(M) into the rear fork of the frame in turn.Last tighten them up with wrench and screw.
Make sure the rear wheel can turn smoothly.
Step 4
1.Take off the plastic screw on the side of seat(A).then insert the Front foot rest in it. tighten
them up with plastic screw(3N*M).
2.Insert the canopy(K) into the holder of seat.