Cochlear Baha 5 - Operating the Baha 5 Sound Processor; Powering On;Off and Status; Program Selection and Streaming; Volume Control and Keylock

6
Before You Begin:
NOTE: Cochlear
™
Baha
®
Sound Processors
CANNOT be paired
bimodally with the Phone
Clip. The Phone Clip can
only be paired with one
hearing device; Baha 5 Sound
Processor or hearing aid.
Ensure Phone Clip is fully charged
and Baha 5 Sound Processor or
hearing aid has a new battery. You
may experience connectivity issues
if battery power is low.
1
Turn off ReSound Hearing Aid.
2
Turn on Phone Clip and remove
silver cap.
Switch on
Remove cap
3
Press the white pairing button
on Phone Clip.
NOTE: The Phone Clip LED
will flash yellow indicating
that pairing mode has been
activated. Pairing mode is
active for 20 seconds.
4
Turn on the Resound Hearing
Aid. The hearing aid pairing
is successful when the yellow
flashing light on the Phone Clip
turns solid.
1
Turn off Baha 5 Sound Processor.
2
Turn on Phone Clip and remove
silver cap.
Switch on
Remove cap
3
Press the white pairing button
on Phone Clip.
NOTE: The Phone Clip LED
will flash yellow indicating
that pairing mode has been
activated. Pairing mode is
active for 20 seconds.
4
Turn on Baha 5 Sound Processor
by closing the battery door.
The Baha 5 Sound Processor pairing
is successful when an audible melody
plays in the sound processor.
Phone Clip Pairing
or
or
or