Cochran EMC-16 Manual

Any time the ‘BATT’ legend is on, battery voltage is below 2.5 volts
and batteries should be changed. When ‘BATT” legend is flashing,
battery voltage is below 2.2 volts and batteries MUST be changed.
BATT
WARNING
METRIC
Any time the “WARNING” legend is on and/or flashing, some parameter is out of
bounds. Look for the offending parameter that is flashing on and off every second.
When ‘METRIC’ legend
is on, the unit is
computing in Metric
variables and displaying
data in Metric units.
Surface Interval
(Never Flashes)
D
I
V
E
DEPTHMAXBOTTOM
TEMPFLY
SURF
Dive Number
& Time to Fly
(Never Flash)
Max Depth
(Never Flashes)
Bottom Time
(Never Flashes)
Temperature
(Flashes if less than 20 or
greater than 99 degrees F,
or sensor is malfunctioning)
DEPTHMAX
TEMP
WARNING
DEC
DEPTHBOTTOM
CEIL
W ARNING
REMAIN TIME
Depth
(Flashes when depth
is less than Ceiling.)
OTU
(Flashes when user
set maximum value
is exceeded.)
Ceiling
(Flashes if depth
is less than ceiling.)
Main
Screen
Alternate
Screen
WARNING
Sensor Failure
(Sensor malfunction,
‘T’ is Temp Sensor
‘d’ is Depth Sensor)
CNS
(Flashes when user
set maximum value
is exceeded.)
PO2
(Flashes when user
set maximum PO2
value is exceeded.)
Depth
(Flashes when user set maximum
depth or 327 feet is exceeded or
sensor is malfunctioning.)
Main
Screen
Alternate
Screen
NDC
A
S
C
T
N
E
BOTTOM
TEMP
W ARNING
REMAIN TIME
DEPTH
Air Only
NDC
A
S
C
T
N
E
DEPTHMAXBOTTOM
TEMP
W ARNING
REMAIN TIME
DEPTH
Ascent Rate Bar Graph
(Flashes when ascending too
fast based on Ascent rate
alarm setting via Analyst)
NDC Time Remain
(Flashes when two minutes
or less remain before entering
Decompression mode)
Temperature
(Flashes if less than 20 or
greater than 99 degrees F,
or sensor is malfunctioning)
Depth
(Flashes when user
set maximum depth
is exceeded.)
Depth
(Flashes when 327 feet
is exceeded or sensor
is malfunctioning)
Air Only
Sensor Failure
(Sensor malfunction,
‘T’ is Temp Sensor
‘d’ is Depth Sensor)
Single Beep
Double Beep
Two Tone
High to Low Sweep
Low to High Sweep
TYPES OF AUDIBLE WARNINGS
Depth Alarm, two minutes of NDC Time Remaining,
Entering Decompression.
Oxygen Toxicity (CNS, OTU, PO2).
Sensor Malfunction.
Ascent Rate (Continuous).
Depth Shallower than Decompression Ceiling (Continuous).
Most Warnings are issued for five seconds and repeated every two minutes
NDC
A
S
C
T
N
E
DEPTHBOTTOM
TEMP
W ARNING
REMAIN TIME
..
6
Setting Alarm
Time
Clock Alarm
Off
Clock
Main Menu Selection
Setting Time
wo/Alarm
Setting Time
w/Alarm
If the Clock Mode is not enabled via the Analyst Personal Computer Interface
the following screens will not be visible nor accessable by Touch Programming .
Clock Mode
w/Alarm
Programming the Clock Time and Alarm settings follows the same sequence
as Touch Programming.
Short Contacts 1 & 2 with a Coin
or other highly conductive metal object
to access Clock Alarm setting screen.
Bridge Contacts 1 & 2
with wetted fingers to
access Clock Mode..
Short Contacts 1 & 2
with a Coin selects the
next programming option.
Clock Mode must be exited before commencing a Dive.
Clock Mode Programming
When the Clock Mode is enabled, the Clock Menu Screen will be the first screen
that is displayed when in Touch Programming.
Bridge Contacts 1 & 2
with wetted fingers to
toggle Clock Alarm on/off.
Clock Alarm
On
Short Contacts 1 & 2 with a Coin
or other highly conductive metal object
to access Clock time setting screen.
Flashes once
per second.
Short Contacts 2 & 3 with Coin
to increment digit value.
(Digit being programmed flashes)
Bridge Contacts 1 & 2
with wetted fingers to
select next digit.
Short Contacts 2 & 3 with Coin
to increment digit value.
(Digit being programmed flashes)
Clock Mode
wo/Alarm
Bridge Contacts 1 & 2
with wetted fingers to
select next digit.
Short Contacts 1 & 2
with a Coin selects
the Clock Mode.
Alarm will sound and Taclite
will flash for one minute at
this time every 24 hours.
Bridge Contacts 1 & 2
with wetted fingers to
select next digit.
Short Contacts 1 & 2 with a Coin until unit
issues two beeps and exits to Surface Mode.
Clock and Alarm times are displayed
using a 24 hour Clock. 15:16 = 3:16 pm.
5
Tap Unit at any time to enable the Alternate Screen and Fiber Optic back light.
Deco Ceiling
(Don’t go above this
Depth for optimum
Decompression)
Bottom Time
(So far this dive)
Current PO2
(in ATA)
NDC Time Remain
(Time you can stay at
current depth without
Decompression)
Ascent Rate
(Bar Graph shows
current Ascent Rate)
(5 bars = 60 fpm)
Deco Stop Times
(Alternates between
Total Deco Time & time
at the current Stop)
Dive Mode
Decompression Mode
Air
Temperature
Surface Interval (No Nitrogen)
Diagnostic Mode (Unit Turning on)
Surface Interval (With Nitrogen)
Water
Temperature
D
I
V
E
BATT
NDC
DEC
A
S
C
T
N
E
DEPTHMAXBOTTOM
CEILTEMP
WARNING
REMAIN TIME FLY
SURF DEPTH
METRIC
.. ..
TEMP
A
S
C
T
N
E
SURF
Barometric Altitude
(2500 feet per bar
No bars = 0 to 2500)
..
Main
Screen
Alternate
Screen
DEPTHMAX
Main
Screen
Main
Screen
Main
Screen
Alternate
Screen
Alternate
Screen
Alternate
Screen
Nitrox O2%
(Current Blend
set point)
OTU Oxygen
Toxicity in %
Max Depth
(Of current dive)
CNS Oxygen
Toxicity in %
Battery
Voltage
OTU Oxygen
Toxicity in %
Nitrox O2%
(Blend #1 Set Point)
Fresh batteries are 3.2 volts. Suggest change
at 2.1 volts. MUST change before 1.6 volts
D
I
V
E
DEPTHMAXBOTTOM
TEMPFLY
SURF
A
S
C
T
N
E
NDC
A
S
C
T
N
E
DEPTHBOTTOM
TEMPREMAIN TIME
..
Depth
(Depth you are
currently at)
CNS Oxygen
Toxicity in %
DEC
A
S
C
T
N
E
DEPTHBOTTOM
CEILREMAIN TIME
DEPTH
..
Bottom Time
(Of the last dive)
Surface Interval
(Amount of time
since the last dive)
Dive of “Day”
(Repetitive Dive
Number)
Time To Fly
(Hours before
safely flying.)
Max Depth
(Of the last dive)
DEPTHMAX
TEMP
Deco Dive
(Water Temperature)
Surface Interval
(Amount of time
since the last dive)
Turn on by touching
closest two Contacts
on the side with
wetted finger or coin.
Unit automatically turns
off one hour after a dive
or one hour after being
turned on. Bridging
contacts 1 & 2 will make
unit stay on for another
hour.
www.divecochran.com
Ph 972.644.6284 800.856.3483 (US)
Fax 972.644.6286 877.288.3483 (US)
Undersea Technology
Cochran
Cochran EMC-16
One Blend Nitrox
DISPLAY SCREENS
© 2005 Cochran Consulting, Inc.
“CardEMC16_FO2” 01December06
1

Cochran EMC-16 Specifications

General

Brand	Cochran
Model	EMC-16
Category	Diving Instrument
Language	English