KCT-510 KEYCHAIN REMOTE CONTROL
4
Remarks
Reminders
• This product must be used in combination with at least one COCO receiver. The wireless system can
be expanded indefinitely with other COCO remote controls and/or receivers.
• This product is a remote control for switching one or more COCO receiver(s) on and off.
• The dimming function only works if the concerned receiver supports this function.
• If the product does not work or does not work properly:
- Check the correct placement and/or function of the battery (replace if necessary).
- Check step for step whether the concerned receiver is programmed correctly.
- Make sure the set "house code" (see [3 - 4]) of this product is the same as on the COCO receiver(s)
that are to be controlled.
- Someone else in the area may be using the same code. Set the system to a different house code.
Safety instructions
• When using this product to control an outside door drive system (e.g. a garage door), the supplier is not
responsible for damage resulting from an intruder who cracks the code and/or due to a lack of sensors
to prevent contact with obstructions during the opening/closing of outside doors.
• Do not expose this product to excessive heat, direct sunlight or moisture.
• Remove the battery from this product if it will not be used for an extended period.
• Do not attempt to repair this product. If the product is damaged or if you are in doubt about the proper
operation, take the product back to the place of purchase.
• Never use COCO products for life support systems or other applications in which equipment
malfunctions can have life-threatening consequences.
• Do not use the product in damp areas. Clean the device with a clean cloth.
Power
• Replace the battery if the transmit indicator no longer lights when the on/off button is pressed.
• Only use a 3 Volt CR2032 lithium battery.
• Do not throw the battery into an open fire.
To Next Page
Loading...
Need help?
General
