To Next PageTo Next PageWhy does wood start to smoke when sanding with my Cocraft HBD500?
If the wood starts to smoke when using the Cocraft Sander, it's likely because the sandpaper or belt is smooth or clogged with sap. The solution is to change the sanding disc paper or belt.
What to do if my Cocraft Sander slows down when sanding?
If your Cocraft Sander slows down while sanding, it's likely that you're applying too much pressure to the workpiece. Try applying less pressure.
How to fix a Cocraft Sander when the motor does not start?
If the motor of your Cocraft Sander doesn't start, it could be due to a defective switch or power supply. Replace the defective part before you continue.
Essential safety guidelines for operating the equipment and protecting users.
Safety rules specific to bench sanders, covering placement and operation hazards.
Explanation of various warning symbols used in the manual for safety.
Step-by-step guide on how to remove and replace the sanding disc.
Guide to adjusting the sanding belt to ensure it runs centrally on rollers.
Essential safety guidelines for operating the equipment and protecting users.
Safety rules specific to bench sanders, covering placement and operation hazards.
Explanation of various warning symbols used in the manual for safety.
Step-by-step guide on how to remove and replace the sanding disc.
Guide to adjusting the sanding belt to ensure it runs centrally on rollers.
General