Code Electronic A24 - Editing Chase Programs

To Next Page

To Previous Page

Edit of chase program

1. Press Chase key for about 2 seconds to make LED blinking. It is in chase program edit state.

2. Choose chase program number. Number key 1-28 can be chosen with page key.

For example, if chase program 1 will be edited, press number key 1. Its LED will be blinking.

3. Use direction key to choose the chase step number. If current step is the last one (with * mark) or

chase program is empty, press right direction key to add a new step.

4. Use Ch1~Ch24 slider to control the brightness of different channel.

5. Repeat step 3-4 to set the brightness of next chase step.

6. In program edit process, use direction key to check the scene effect of every chase step.

7. Repeat step 2-6 to edit other chase program.

8. Press Chase key for about 2 seconds to quit from program edit state.