Precautions
Observe these precautions when installing the VisionView to reduce the riskof injury
or equipment damage:
l
VisionView
®
is intended to be supplied by a NRTL listed power supply with a
minimum output rated 24VDC, 2A with a maximum short circuit current
rating of lessthan 8A and a maximum power rating of less than 100VA and
marked Class 2 or Limited Power Source (LPS). Anyother voltage creates
a riskof fire or shock and can damage VisionView components. Applicable
national and local wiring standards and rules must be followed.
l
To reduce the risk of damage or malfunction due to over-voltage, line noise,
electrostatic discharge (ESD), power surges, or other irregularities in the
power supply, route all cablesand wires away from high-voltage power
sources.
l
Do not install VisionView in areas directly exposed to environmental hazards
such as excessive heat, dust, moisture, humidity, impact, vibration,
corrosive substances, flammable substances, or static electricity without a
protective enclosure.
l
Do not expose the touch screen to direct sunlight for prolonged periods of
time.
l
Do not place heavy, hard or sharp objects directly on or against the touch
screen. VisionView does not contain user-serviceable parts. Do not make
any electricalor mechanicalmodifications. Unauthorized modifications may
void your warranty.
l
Changes or modifications not expressly approved by the party responsible
for regulatory compliance could void the user’s authority to operate the
equipment.
l
VisionView is intended for indoor use only.
2
To Next Page
Loading...