Cohda Wireless MK5 RSU - Connecting MK5 RSU Kit; Connect GNSS and DSRC Antennas; Seal Antenna Joints with Self-Fusing Tape

2 Connecting MK5 RSU Kit
2.1 Connect GNSS and DSRC antennas.
2.2 Wrap the N-connector and antenna joints with provide Self-Fusing Rubber Tape to
prevent water intrusion.
-Cut a small length (10cm) of Self-Fusing tape.
-Remove backing film.
-Begin wrapping Self-Fusing tape around the N-connector and antenna joint. Stretch tape
to 300% and wrap it spirally around the object with a 50% overlap.
-Repeat steps and ensure at least one complete wrap is applied.
-Cut off any excess.
Ensure surface
is clean
Stretch tape
and wrap
Done