SIENA
A73021514 39
EN
ENEN
EN
Choose the location of the thermal emitter following the minimum distances indicated below:
Note: If the windowsill protrudes less than 20 mm, the gap above the emitter could be disre-
garded.
3. ELECTRICAL CONNECTION
The electric thermal emitter must be connected to the mains supply (230 V ~ 50 Hz) through its
plug. The maximum permissible impedance of the mains at the connection point will be:
Z
max
= 0.18 Ω
In addition, the following warnings must be considered:
- The thermal emitter must not be located underneath an electrical outlet or switch.
- The electric line should be protected with a high sensitivity differential device.
4. MOUNTING
The thermal emitter must be held by its handles, as shown in the following image:
To Next Page
Loading...