Cointra SIENA - Wall Mounting Procedure; Bracket Installation Guide; Securing the Emitter

SIENA
40 A73021514
EN
ENEN
EN
The electric emitter shall be fixed to the wall by the adjustable brackets, screws and wall-plugs
supplied with the emitter, using the template printed on the box.
If for any reason the template is missing, you can follow the instructions below:
1. Make sure you keep your eye on where the lower hole on the wall is.
Model
Dimensions (mm)
No. of
brackets (*)
A B
SIENA 500
160 80
2 + 1
SIENA 750
240 160
SIENA 1000
320 160
SIENA 1200 400 240
SIENA 1500
560 320
(*) The first number corresponds to the number of plastic brackets on which the emitter hangs, and the
second number corresponds to the number of metal locking brackets which fixes the emitter to the wall.
2. Screw in each of the brackets using the lower hole and mark the upper holes of each
wall bracket.
3. Drill all the marked locations in the wall and insert
the wall-plugs, screw the brackets to the wall and hang
the emitter.
4. Metal locking bracket: Tighten the screw at the top of the bracket until emitter is locked
in position.