@ 3.TimerButton
• Press to set the timing of Delay off and Delay on.
• Press the Timer button to change the timing of Delay-off or Delay on by a I-hour
increment up to 24 hours.
• Delay off-while the dehumidifier is in operation, first press the timer button, the timer
indicator light will illuminate in the panel. Press the timer button
continuously to have the unit power off later by I-hour increment up to 24 hours.
• Delay on-while the dehumidifier is not on(but plugged in power) first press the
timer button, the timer indicator light will illuminate in the main/round display screen.
Press the timer button continuously to have the unit power on later by I-hour
increment up to 24hours.
• If there is no operation within 5 seconds after pressing the timing button, the timer
setting will automatically exit.
• In the state of timer setting, press the timing button again will display the current
remaining time.
• If you want to cancel timing , please press timer button up to 00 until timer indicator
light off, then timing will be canceled successfully. Or pressing the power key to turn
off the unit before time finishes counting down, the setting timer will be canceled.
• While the timer run, the timer indicating light illuminates. After setting the timer , the
display switch back to show the humidity.
0 4.Setting
Press setting button to choose dehumidification mode that you want, there are two
modeswiththis dehumidifier,continuousdehumidificationmode[ CO] and comfort
mode[ RI—I of courseyoucansettinghumiditywhichto relativehumidity30%,40%,
50%, 60%, 70%, 80%.
[ C O ]Continuous Dehumidification Mode :
1)Presssettingbutton,there is "CO" on LEDscreenandflashuntildisplayswitch
back to show the real humidity, it means dehumidifier is in continuous dehumidification
mode which will work continuously , you can adjust fan speed according to your needs.
2)Ifyouwantto set humidity,presssettingbuttonagainuntilyousee"' O"on LED
screen, continue to press setting button set humidity 30%, 40%, 50%, 60%, 70%,
80% in 10% increments.
3) If you have setted the humidity and want to change to another, just press setting
button, LED screen will show humidity number that you setted up, continue to press
setting button set humidity that you want.
08
To Next Page
Loading...