7
1-800
-3DRY-ICE
Section 5
Section 5 Section 5
Section 5 Troubleshooting
Troubleshooting Troubleshooting
Troubleshooting
Problem Check This
Machine will not start.
1. Is the unit plugged in?
2. Is the power Switch in the ON position?
3. Reset E-stop.
4. Is the FEEDER RESET ready? If not, press to
reset.
5. Is the 24V Power fuse blown (the indicator will be
red)?
Machine will NOT blast.
1. Is the air supply CONNECTED and the air supply
on?
2. Is the air supply gauge showing pressure?
3. Is the OPTIONAL pressure regulator open?
4. Is applicator cable CONNECTED to Cub and the
applicator?
5. Is the BLAST pressure gauge showing pressure
when the trigger is pulled?
6. The NOZZLE may be clogged, blast with air only
to unclog the nozzle.
Machine blasts AIR but NOT
pellets.
1. Set feeder speed.
2. Check Vibrator.
3. Unclog NOZZLE.
If these recommendations DO NOT solve your problem, contact our Technical Service hotline:
1-800-777-9101.
To Next Page