The air cleaner element needs to
be cleaned or replaced periodically
(see chart for cleaning/replace-
ment intervals). The air lter
element will need to be cleaned
more often if Go Kart is ridden in
muddy, wet, or dusty conditions. A
clean air lter will help the Go Kart
to run at peak performance allow-
ing better gas mileage, more power
and will protect the engine from the
damaging effects of dirt entering
the engine.
Clean air lter more frequently if
Go Kart is driven in wet, muddy
or dusty conditions.
Driving in the above conditions
without cleaning frequently can
plug up the air lter which can
cause poor gas mileage, low
power and cause damage to the
engine.
CAUTION
3
AIR FILTER
MAINTENANCE
1
4
5
Air Filter
Assembly
Air lter removal,
inspection and
cleaning instructions
1. Locate the air lter assembly (1)
2. Remove the Air lter assembly
cover by removing the air lter
cover knob (2).
3. Remove the air lter element
from the assembly by removing the
wing nut (3)
3. Remove the foam element (4)
from the paper air lter element
(5) and clean foam element with
mild soap and water. Rinse and
squeeze out excess water and allow
to dry .
Note: If foam element (4) is
damaged, replace.
4. Inspect the air lter paper
element (5) for dirt and damage. If
dirty, gently tap element on ground
to remove any excess debris.
Gently blow out element from the
inside with compressed air. If
element is too clogged or damaged
for continued use, replace the
element.
5. Once cleaned or replaced,
re-install.
2
24
To Next Page
Loading...
Need help?
General
