EasyManua.ls Logo

Coleman 90363 - User Manual

Coleman 90363
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
90363
110-120V~60Hz, 12A at 68°F (20ºC)
Coleman
OWNER’S MANUAL
DO NOT RETURN THIS ITEM TO THE STORE OR
WEBSITE WHERE IT WAS PURCHASED. PLEASE
VISIT BESTWAYCORP.COM/SUPPORT
FOR QUESTIONS, OR FOR DEFECTIVE OR
WARRANTY CLAIMS.
Website: bestwaycorp.com/support
EN
303021241703_90363_14x21cm_美规COLEMAN SPA说明书_封面

Questions and Answers

  • T
    Todd ToddAug 13, 2025
    How to clean my Coleman 90363 Swimming Pool water?
    • A
      Albert TuckerAug 13, 2025
      If the water in your Coleman Swimming Pool is not clean, it could be due to insufficient filtering time. Try increasing the filtration time. Also, a dirty filter cartridge can cause this issue, so clean or replace it. Make sure you follow the chemical manufacturer’s instructions for proper water maintenance.
  • J
    Jesus SpearsAug 16, 2025
    Why is my Coleman 90363 Swimming Pool pump not working?
    • Z
      zrichardsonAug 16, 2025
      If your Coleman Swimming Pool pump isn't operating, it might be due to a power failure. Check the power source to ensure it's functioning correctly.
  • H
    Heather MorrisonAug 20, 2025
    What to do if my Coleman 90363 Swimming Pool pump does not heat properly?
    • H
      hillharoldAug 21, 2025
      If your Coleman Swimming Pool pump isn't heating properly, several factors could be the cause. First, check if the temperature is set too low and adjust it to a higher setting. A dirty filter cartridge can also affect heating, so clean or replace it. If the thermal cut-out has activated, unplug the pump and let it cool until the water temperature reaches 95°F (35°C) or lower before restarting. Finally, ensure the spa is covered to retain heat.
  • B
    Brooke JohnsonAug 25, 2025
    How to fix Coleman Swimming Pool leakage?
    • Y
      yjuarezAug 25, 2025
      If your Coleman Swimming Pool is leaking, it could be due to a tear or puncture; use the provided repair patch to fix it. Another possible cause is a loose air valve. To check for this, cover the air valve with soapy water to see if air is leaking. If it is, deflate the spa, hold the backside of the air valve from the inside, and turn the wrench clockwise to tighten it.
  • L
    Lindsay RichardsonAug 28, 2025
    What to do if Coleman Swimming Pool control panel is not working?
    • D
      Dylan OwensAug 28, 2025
      If the control panel on your Coleman Swimming Pool isn't working, it might be auto-locked after 5 minutes of inactivity. To unlock it, press the button for 3 seconds. If that doesn't work, try restarting the pump by unplugging it and plugging it back in.
  • J
    Julian HaneySep 1, 2025
    Why is water leaking from the Coleman 90363 pump adapters?
    • D
      Daniel PetersonSep 1, 2025
      If water is leaking from the adapters between the pump and your Coleman Swimming Pool, it could be due to several reasons. First, check if the seals are missing inside the pump adapters. If so, insert the stopper caps on the spa ports to prevent water from escaping and disconnect the pump. Also, the seals might not be in the correct position; open the gears and place them correctly. Ensure the adapters are hand-tightened correctly. If there is still leakage, tighten the adapter until it stops.
  • B
    Brian GarzaSep 4, 2025
    Why doesn't the massage system work on my Coleman 90363?
    • D
      Daniel BrockSep 4, 2025
      If the massage system in your Coleman Swimming Pool isn't working, it could be because the air pump is overheating. Unplug the pump and wait two hours until it cools down, then plug it back in and press the massage system button. Alternatively, the massage system may have stopped automatically; press the massage system button to reactivate it.
  • K
    Kimberly PetersonSep 8, 2025
    Why are my Coleman Swimming Pool pump adapters not level?
    • B
      Brian CummingsSep 8, 2025
      One characteristic of PVC is that it changes shape, which is normal. Elevate the Coleman Swimming Pool pump with wood or another type of insulated material to bring the pump's adapters level with the spa's adapters.

Summary

Important Safety Instructions

Electrical Safety Precautions

Covers GFCI testing, cord safety, shock risks from metal surfaces, and appliance proximity.

Health and Usage Safety

Addresses risks related to children, drowning, water temperature, pregnancy, and suction fittings.

General Safety and Health Advice

Physician Consultation and Cautions

Recommends consulting a physician for specific health conditions and general cautions for use.

Usage Warnings and Precautions

Details warnings against alcohol, drugs, strenuous exercise, prolonged immersion, and electronics.

Specific Risk Reduction Guidelines

Electrical and Drowning Prevention

Guidelines to reduce the risk of electrocution and child drowning during spa use.

Overheating and Pregnancy Precautions

Advice on preventing overheating and specific precautions for pregnant users.

Warning Label Application

Instructions on where and how to affix the provided warning label for safety.

Selected Location and Installation Site

Indoor Installation Considerations

Special requirements and humidity considerations for indoor spa installations.

Outdoor Installation Considerations

Notes on water spillage near drains and avoiding prolonged direct sunlight.

Pre-Setup Checklist and Parts Identification

Parts Check Procedure

Guidance on examining equipment for damaged or missing parts before setup.

Model Specifications

Details on the Coleman AirJet S100104 model, including size, capacity, and temperature ratings.

Installation and Winter Setup

Winter Setup Instructions

Recommendations for setting up the spa during winter to prevent damage and ensure functionality.

Installation Steps Overview

Visual guide for the initial installation steps of the spa system.

GFCI Test Procedure

Testing the GFCI

Step-by-step instructions for testing the Ground Fault Circuit Interrupter before use.

Important Usage Notes

Key notes regarding extension leads, air compressors, and handling the spa.

Using the Spa: Control Panel Overview

Lock;Unlock and Timer Functions

Explanation of the control panel's lock function and the power-saving timer settings.

Heat Button Operation

Guide on how to activate and monitor the spa's heating system.

Spa Control Panel Functions

Massage, Temperature, and On;Off Controls

Details on operating the massage system, adjusting temperature, and powering the unit on/off.

Units, Timer LED, and Filter Controls

Information on unit conversion, timer indicators, and operating the water filter.

Winter Use Instructions

Freeze Shield System

Explanation of the Freeze Shield system for preventing water freezing.

Heating Duration and Power Specs

Reference table for heating duration based on temperatures and power specifications.

Maintenance Procedures

Adding Air and Cover Care

Instructions for maintaining air pressure and cleaning the spa cover.

Filter Cartridge Maintenance

Guidance on checking, cleaning, and replacing filter cartridges for water clarity.

Water Maintenance and Treatment

Recommendations for cleaning the spa, changing water, and maintaining chemical balance.

Water Quality and Chemical Management

Chemical Treatment Guidelines

Instructions for using chemical tablets and liquids for water treatment.

Water Chemistry Recommendations

Recommended pH, Total Alkalinity, and Free Chlorine levels for spa water.

Disassembly and Storage

Draining the Spa

Step-by-step instructions for safely draining water from the spa.

Spa Cleaning and Deflation

Cleaning the Spa

Methods for cleaning the spa walls and surfaces using soap and water.

Deflating the Spa

Instructions on how to deflate the spa chamber for packing and storage.

Spa Repair Procedures

PVC Part Repair

Steps for repairing tears or punctures in the spa's PVC material.

Tritech PVC Material Repair

Procedure for repairing damage to Tritech PVC material using patch and glue.

Troubleshooting Common Problems

Pump and Massage System Issues

Solutions for problems like pump not operating, not heating, or massage system not working.

Spa Water and Control Panel Issues

Troubleshooting for water clarity, spa leakage, control panel errors, and GFCI failures.

Water Leaks and Chemical Advice

Resolving water leaks from adapters and guidance on water maintenance chemicals.

Understanding Error Codes

Water Flow Sensor Errors

Diagnosing and resolving errors related to water flow sensors and blockages.

Temperature and Thermometer Errors

Troubleshooting issues with the spa's thermometer readings and temperature limits.

Connection and Thermal Cut-off Errors

Addressing errors related to thermometer connections and thermal cut-out faults.

Coleman 90363 Specifications

General IconGeneral
BrandColeman
Model90363
CategorySwimming Pool
LanguageEnglish

Related product manuals