Coleman 9903 Series - Set up the Grill; Installing 1 lb. Propane Cylinder

English - 6
9. Insert the towing handle into the handle leg
(Step a in Fig. 12).
10. Press buttons in on towing handle while sliding towing
handle into handle leg. Continue sliding into handle leg
until buttons lock into place. (Step b in Fig. 12)
NOTE: Plastic Feet should be facing away from the grill.
Fig. 12
a
b
Plastic Feet
11. Move handle leg in a
clockwise direction
to slide out of leg
brackets, then back
in a counterclockwise
direction to fold legs
together.
12. Press legs firmly
downward until legs lock
into clip. (Fig. 13)
Fig. 13
Clips
13. Once the legs are locked
in position, turn the grill
back over so the lid is
again facing up. The grill
can now easily be moved
to any location in your
campsite or backyard
by grasping the towing
handle. (Fig. 14)
Fig. 14
Set up the Grill
1. Open up the grill from the folded position. Place one foot on
the towing handle, grasp the carry handle, and lift up and
toward you (Fig. 15). Continue to pull up until the grill stand
is fully extended. (Fig. 16)
2. Lock the grill top into the leg brackets as shown. (Fig. 17)
Fig. 15 Fig. 16
Fig. 17
Locked
3. Replace the water pan (Fig. 18), place the cooking grates
(Fig. 19), and then close and latch the grill lid.
Fig. 19Fig. 18
NOTE: In order to operate lid latch, first move the latch into open
position before lid is closed. Close lid and move latch to
closed position.
Installing 1 lb. Propane Cylinder
NOTE: Your 9903 Series grill is set up from the factory to use a
1 lb. disposable propane cylinder.
WARNING
Only cylinders marked “Propane” must be used.
WARNING
• This procedure MUST be performed OUTDOORS only! Read
and follow the directions on the cylinder.