Coleman CM04143N - User Manual

Questions and Answers

T
Thomas WellsAug 1, 2025
What to do if Coleman CM04143N Inverter has zero output from receptacles?
- C
  Catherine ThorntonAug 1, 2025
  If your Coleman Inverter shows zero output from the receptacles, it could be due to several reasons. The engine speed might be too slow, in which case you should adjust the engine speed with help from a repair shop. There might be open or shorted wiring, so you should clean and reconnect all wiring. Another cause may be a faulty capacitor, which would need to be replaced. Also, check for open or shorted rotor or stator windings by testing wiring resistance and replacing the winding if necessary. Finally, an open rectifier could be the problem, so test the rectifier and replace it if needed.
C
carpenterjerryAug 7, 2025
Why is the output voltage low under load on my Coleman CM04143N Inverter?
- R
  robert75Aug 7, 2025
  A low output voltage under load in your Coleman Inverter can stem from a few issues. First, the engine speed may be too low at full load; consider adjusting the engine speed, asking a repair shop for help. Also, an open rectifier could be the culprit; test and replace it if necessary. Finally, check if you're applying an excessive load and reduce it if so.
D
dawnjordanAug 13, 2025
How to fix low output voltage with no load on a Coleman CM04143N Inverter?
- J
  Julie ParksAug 13, 2025
  If your Coleman Inverter has low output voltage with no load, several factors could be responsible. The engine speed might be too slow, so adjust the engine speed with help from a repair shop. It could also be an open rectifier, which would require testing and replacement if necessary. A faulty capacitor can also cause this issue, so replace the capacitor. Additionally, check for open or shorted rotor or stator windings by testing wiring resistance and replacing the winding if needed. Lastly, the alternator might not be magnetized; in this case, re-magnetize the alternator.
G
Gregory OrtegaAug 18, 2025
What to do if Coleman CM04143N has erratic output voltage?
- D
  dennisjohnsonAug 18, 2025
  If your Coleman Inverter is showing erratic output voltage, the cause could be dirty, corroded, or loose wiring connections. Referring to the wiring diagram, clean and reconnect all wiring. Another potential cause is an unbalanced load. Remove all loads, then apply each one individually to determine which one is causing the erratic output.
N
nelsonamandaAug 25, 2025
Why does my Coleman CM04143N have high output voltage with no load?
- H
  Heather RogersAug 26, 2025
  A high output voltage with no load on your Coleman Inverter could be due to a faulty capacitor, which would need to be replaced. Alternatively, the engine speed may be too fast, so adjust the engine speed.